1 min read
Ten ways to extend the life of a cnc pipe bending machine with the correct use of a pipe bender

1. The China CNC pipe bending machine must be well grounded, and the wire must not be less than 4mm2 copper cord. It is not allowed to access the power supply voltage exceeding the specified range. The plug-in cannot be plugged in. The control loop cannot be tested with a meg-ohmmeter, otherwise the device may be damaged.
2. When plugging or unplugging the connector, the wire or cable cannot be pulled to prevent the solder from pulling off.
3, proximity switches, encoders, etc. can not be hit with hard objects.
4. You cannot use a sharp object to collide with the display unit.
5. The electrical box must be placed in a ventilated place, and it is forbidden to work in dust and corrosive gases.
6, can not be installed and changed to PC input and output.
7. The motor steering must be reconfirmed when changing the power of the bender.
8. The pipe bending machine should be kept clean. In particular, it should be noted that there should be no foreign objects in the sliding grooves such as clamping blocks and sliders.
9. Regularly add lubricant to the chain and other sliding parts.
10. The power must be disconnected during cleaning and maintenance.

Comments
* The email will not be published on the website.